Stojan na olepování
Záznam uvidíte za
Device for connecting wooden slats by means of glue and pressure to gluelam planks and gluelam panels with up to 80 mm width. ApplicationGluing presses serve the production of mostly small gluelam panels or planks.
Construction and mode of operationThe operative part of a gluing press consists of a vertical, perforated metal profile, into which the workpiece support is mounted in the lower half and the pressure cylinder in the upper half. Between the workpiece support and the pressure cylinder the glued blanks are stacked and pressed together with the pressure cylinder. The pressure in the cylinder can be built up pneumatically, hand-hydraulically or electro-hydraulically, depending on the type of press. Several of these vertical pressing units are movable mounted next to each other on an upper and lower beam. One or more manually operated downholders prevent the arching of the workpiece under pressure. Upper and lower beam are either connected by triangular, side stands or mounted to a wall. Special equipmentPendulum pressure plate for angular pressingThe pendulum pressure plate for angular pressing is attached to the pressure pad of the pressure cylinder. It is suspended in the middle, as a pendulum and adapts to workpieces whose top edge does not run horizontal but ascending or descending, e.g. steps. Alternative termsSimilar presses |
894
629
439
188
181
135
202
320
200
152
127
62
134
15
29
91
131