Designation for a contour milling aggregate of the manufacturer HOMAG, used on edgebanding combination lines for outer profiling the leading and trailing edge of the workpiece with 4 milling motors.

The aggregate enables the manual quick change of tools due to a special tool interface.

In contrast to the aggregates Homag FK 11 and FK13, the aggregate FF32 has 4 milling motors. Because each motor is used for the processing of one of the four edge corners, it is possible to mill in down-cut, which allows the processing of veneer edges.

Technical data

• 4 motors with 0.4 kW each, 200 Hz and 12000 rpm
• per profile and per edge material (wood or plastic edge PP) a separate interchangeable head is required (synchronous movement / counter movement)
• Pneumatic, lateral adjustment of the aggregate between two various positions, in order to set the correct engagement dimension from the control panel after a tool change (profile change).
• flush milling of the upper and lower edge excesses
• edge thickness max. 3 mm
• plate thickness max. 60 mm
• plate length min. 120 mm single-sided
• plate length min. 80 mm double-sided
• feedrate max. 25 m/min
• feedrate max. 20 m/min for softforming
• plate distance approx. 500 mm
• tool holder HSK25

Options:

Automatic package for radius and bevel cutting with combination tools

• automatic setting of lateral tracking to different edge thicknesses (0.3 - 3 mm)
• chamfer and radius setting automatically
• max. edge thickness
• for R 1.5 = 0.6 mm
• for R 2.0 = 0.8 mm
• for R 3.0 = 1 mm
• chamfer angle approx. 15 degrees

Package for reducing the plate distance

• minimum panel gap for a panel thickness of 60 mm:
• for feedrate 20 m / min: 350 mm
• for feedrate 25 m / min: 400 mm
• minimum panel gap for a panel thickness of 100 mm:
• for feedrate 20 m / min: 400 mm
• for feedrate 25 m / min: 450 mm