HOMAG DRIVE 5
Záznam uvidíte za
Under "Drive 5" all 5-axis spindles are connected to the Homag group. The name has initially appeared in 2003 but not for all 5-axis spindles back then. From 2005 on, with the introduction of Drive 5C a type system has been introduced which is based on it. With this all 5-axis spindles used in the Homag group received a name beginning with "Drive 5" as well as a detailed identification of the exact model. | HOMAG DRIVE 5
|
Obrázky a videa
Agregáty
Zdroj: Höchsmann GmbH
©
CNC obráběcí centrum