HOMAG BAZ 30
Záznam uvidíte za
Short descriptionCNC-machining centre with edgebanding aggregate, which was introduced by HOMAG in 1995. The BAZ 30 was presented under the name Genius B30 by HOMAG in 1995. It was meant to be a low-cost alternative to the expensive BAZ 20. EquipmentThe machine was based on the same basic configuration as the BAZ 20, but had far fewer options. Initially, the machine was only available with a pod and rail table with a size of 3.250 x 1.200 mm. A short time later, the machine was also available with a table length of 5.000 mm. For the first time, as an affordable alternative to an edgebanding aggregate with its own Y-axis, a solution with an edgebanding aggregate insertable into the working spindle was presented. 2 versions were available:
The use of exchangeable edgebanding aggregates was made possible by the introduction of a new aggregate interface, which offered a supply for the pneumatic as well as for an electronic interface in addition to a support for horizontal aggregates and a C-axis. See also:
| HOMAG BAZ 30
WOOD TEC VALUE
Zjistěte nyní tržní hodnotu vašeho stroje HOMAG BAZ 30 pomocí WOOD TEC VALUE. Zdarma, rychle a nezávazně! Oceňování strojů |
894
622
436
190
181
134
202
324
197
149
125
63
139
15
29
99
124