Pusher cross cut saws of the manufacturer Paul with Paul´s typical 20° backwards inclinable workpiece supporting table that is used since the 1980s. Additional side-pressure devices are not necessary because of the plane inclined towards the length stop which avoids an additional positioning of workpieces.

• Max. workpiece thickness of 140mm/ 250mm (optional)
• Infeed lengths up to 12m
• Cutting stations with pneumatic feed known from the field of under cross cut saws are installed (models 15AP, 17AP and 27AP), they differ in cutting dimensions (among others)
• standard sensor for length capture by use of a pusher (On its way back the pusher overruns the following workpiece and thereby measures the total length of it.)
• Options (selection):
• Detection of chalk marking
• Length sorting, destacking
• Waste gate
• Inkjet printer

Successors

• Push_Cut_CX
• Push_Cut_CX-Z - with clamp gripper