Wood defect cuttingTechnical feature/ equipment of optimization cut-off saws to conduct defect scanning and cutting on the workpieces. The result are high-quality workpieces and waste. Marking and registration of defectsManual marking via flourescent chalkThe marking of workpieces via chalk lines often is conducted directly before the trimming by one or two persons, but it is possible to realise the marking well before the trimming process, too. In this case, the workpieces have to be stored and are transfered to the machine later. Movable measuring station with laser cutting markerThe raw worpiece lies within the infeed area of the optimization cross cut saw. The operator controls a laser marking device, mounted at the entry of the machine, which can be moved laterally to the workpiece. The marker has a special measuring system, whilst it moves the marking device along the workpiece and follows the laser line on the workpiece visually. For the view of the workpiece's bottom the marking station may use a mirror. After recognizing a defect, the operator marks the workpiece by setting measurement points without contact (key press). At the same time it is possible to set the quality level. After transfering the workpiece to the trimming station it is cut at the marked points. Stationary measuring stationsee: Touch-Free Marking System Automatic scanning systems |
908
632
434
183
183
138
196
330
209
154
127
60
139
19
27
99
167