"Zwei beamsaws in einer"
One separately moveable, additional pusher affixed at the guide beam of the back supporting table combined with the traditional main slide.
The additional pusher, which is also an independent component as well, can be used together with the main pusher.
It can be automatically positioned in two laterally different positions; with or without the liftable, independent grippers of themain pusher, according to the cutting plan and size of the stripes. This facilitates the simultaneous execution of several cutting cycles (longitudinal and trasversal , panel intake, pivoting, stripe extension) according to the cutting plan
- Differentiated transversal cut of slim stripes
- Transversal and longitudinal cutting in a processing cycle
- Transversal cutting of the last stripes whilst the next panel is stack is being turned and fed to
Differences between the series
- Series SELCO SK 4:
- Independent pusher with 2 grippers, affixed on programmable stop, without lateral positioning
- The system twin pusher allows separate transversal cuts of stripes up to 650 mm width.
- According to the manufacturer, increase in productivity up to 25 %
- Series SELCO WN 6:
- The additional pusher consists of an independent collet chuck with a lateral NC-positioning
- The lateral traversing range allows the transversal cut of different stripes up to 600mm width.
- According to manufacturer - increase of productivity up to 40 %
- Series SELCO WN 7:
- The additional pusher consists of two independent grippers with lateral NC-positioning. The lateral travel range allows the transversal cut of different striped up to 1200 mm width.
- According to manufacturer an increase of productivity up to 60 %
