HOMAG RF 12 Formatting cantilever

Special aggregate

Special unit on HOMAG edgebanders, for formatting longitudinal /transversal the opposite side of the actual format processing part (e.g. double hogging unit) so that both sides to be formatted are exactly parallel to one another in a single operation.

Technical data 2007:

Workpiece measuring with format processing with workpiece projection 30 mm:

- Length: min. 240, max. 2500 mm

- Width: min. 120, max. 1200 mm

- Smallest workpiece: 240 x 120 mm

  • Cantilever front:
  • Positioning stop for format processing in transversal throughfeed
  • Tooth rack engines for horizontal adjustment via servo motor
  • Adjustment speed 1,5 m/sec. positioning stop via servomotor vertically controllable
  • Residual gap around 1000 mm at a length adjustment of 1500 mm
  • Cantilever backside:
  • Reference milling unit with 2 engines for format processing in lengthwise throughfeed
  • Toothrack engine for horizontal adjustment via servo motor
  • Adjustment speed 1,5 m/sec.
  • Milling motor with 6 KW each, wave D= 30 mm, rpm 7200 1/min
  • Processing in Up-cut and Down-cut
  • Milling motors pneumatically controllable
  • Residual gap ca. 1300 mm at a width adjustment of 500 mm

Images

RF 12 Auslegervorderseite
HOMAG
RF 12 Auslegerhinterseite
HOMAG