The gluing aggregate VC-511, on edgebanders, of the manufacturer BIESSE applies the hot melt adhesive on the edge material to the workpiece, automatic cuts it off the roller and presses it against the workpiece.
Technical details
glue tank and application roller
- rapid heating and double thermostat for differentiated temperature control
- electronic device for automatic temperature reduction of the gluing unit, for a defined period of time, when the machine is stopped or idle
- hand lever for quick replacement of the gluing unit (quick-change glue pot)
- the glue pot is completely coated with a non-adhesive material.
- application roller is equipped with a sliding shoe to apply the correct amount of adhesive
- running direction of the glue roller in down-cut with the board
- quick change device of the gluing unit, for easy maintainance and change of the glue type / glue colour
- optional equipped with the BIESSE QM 703 premelting unit
Automatic edge feeding system for edge in roll or strip form
- roll holder with 800mm disc diameter
- when the panel moves forward, the infeed system takes over the feeding of the edge, slipping of the edging material is avoided
- manual, vertical height adjustment at the edge magazine
Cutter knife for automatic cutting of edgeband
- max. roll thickness of 3mm
- max. cross section of 140 mm²
- automatic adjustment of the working pressure, according to the edge thickness at the first pressure roller
Pressure device with plunge controlled pressure roller RPT
- first pressure roller Ø 100mm with a separate air pressure regulator
- two free running pressure rollers Ø 60mm, sanding from top and bottom conical, non-stick coated, one common pressure regulator (optional with servo motor, NC controlled)
