Numerical control of the Homag-Group. Used around the early 1990s on CNC-machining centres such as, for example, the Homag BAZ 10. With the adjustment of the design in 1996 it was finally replaced by the Homatic NC 83.
Properties
- Real-time operating system OS-9
- Menu-guided graphical user interface
- Multiprocessor 32-bit IPC
- 120Mb hard disk space
- 3 1/2 inch floppy drive
- 14 inch color monitor
- Serial interface
- RS232 interface
CNC path control
- 3D - Interpolation linear
- 2 1/2D - Interpolation circular
- 4 axis control (X, Y, Z, C)
- C-Axis as coupled axis to the X-, Y-axis
- Following error control
- Entry system for dimensions metric / inch
- Ramp setting for gentle and fast positioning
- Input / output unit 0,001 mm
- Interpolation range plus / minus 2.00 m
- Influence of through-feed (override) possible at any time
- Block change time <20 ms
- Direct link to the Homatic-SPS
- Alarm texts in plain text
- Programming with commands of the programming language "C" possible (IF, ELSE, CASE, FOR, etc.)