HOLZMA combiTec

Resawing-function for HOLZMA angle plant HKL 300 profiLine.


In addition to the common rip cuts the rip saw is able to conduct final cuts via combiTec-function by precise positioning of the panels and exact cutting at the right points.

The following cross-cut is, as usual, executed by the cross-cut saw. The cross-cut saw conducts a double cross-cut in the area the final cut was made before. By means of the software it is possible to place wooden waste within the cutting pattern on these particular places.

The succeeding cross cut saw normally executes the cross cut and does a double cross cut, where there has been no recuts. The software lays, if possible, the waste on exactly this spot.


combiTec - Funktion
HOLZMA, 2013

Documents (1)