Jointing cutter station 1961 (premilling unit)

• For cutting the edge surfaces of workpieces in panel form
• Cutting in forward (down-cut) or reverse direction and (up- cut)
• Results in flat surfaces suitable for gluing
• Reduces even very small visible tears in the top layer of the support material
• Power (kW): 2 x 2.0
• Frequency (Hz): 200, 12000 min-1
• Max. workpiece thickness (mm): 45 (60)
• Min. workpiece thickness (mm): 6
• Chip removal at feed speed 16 m/min: up to 90 mm²
• Penetration depth up to 5 mm
• Chip thickness max. 3 mm
• 2 penetration-controlled cutter units (can in each case be operated separately):
• 1st unit in reverse direction
• 2nd unit in reverse direction
• Incl. blowing nozzles for blowing away the debris of the panel edges
• With suction hoods including integrated, defined chip removal
• Manual adjustment to workpiece thickness

Options

• Run-in linear stop (infeed fence) can be adjusted in a motordriven manner
• Automatic height adjustment of the tools by means of a pneumatic system

Tools

• Tool for 1961: Diamond cutter K/F 100-48-30 DKN, Z = 2 2 2 front, left run Diamond cutter K/F 100-48-30 DKN, Z = 2 2 2 rear, right run
• Tool for 1961 (workpiece height 50 mm): Diamond cutter K/F 100-53-30 DKN, Z = 2 2 2 front, left run Diamond cutter K/F 100-53-30 DKN, Z = 2 2 2 rear, right run
• Tool for 1961 (workpiece height up to 45/60 mm): Diamond cutter front and rear, incl. protective hoods Ø 100-63-30 mm, Z = 2 + 2 + 2, 1x left run, 1x right run (chip removal 2 mm = 60 mm workpiece height) (chip removal 3 mm = 45 mm workpiece height)