Scoring sawIn conjunction with the main saw blade this sawing aggregat is used for the hogging or the "scoring" of the sensitive coating of a particle or fibreboard or cutting and therefore pre-scoring the cutting edges of the main saw blade. Through the use of scoring aggregates (short: scorer) splinterfree cutting edges are achieved also with hard and frangible surface coating, because the cutting force of the main saw blade are not (any longer) directed against the sensitive cutting edges. The scoring saw blade is approximately 0.1 mm up to maximum 0.2 mm wider then the main saw blade. Scoring aggregates work in a clockwise circle (down-cut) and with a higher speed than aggregates of the main saw. Utilized are divided scoring saw blades (consisting of two parts, which are ajusted through fine thread or with intermediate rings) or conical scoring saws (cutting width is adjustable through the depth of the cut). VersionsScoring of the bottom side of a coated panel
Scoring of the top of a coated panel
Scoring of the vertical edges in the cutting process of panel packs
soft- and postforming edges
Scoring for the parquet production
Scoring in finger jointing technology
|
895
620
433
189
181
135
202
325
197
155
124
62
139
14
29
99
121