Pneumatic trimmer
You see the entry in
SummaryUnit at coil magazines at edgebanders. DescriptionAfter banding, the glued edge band is separated from the coil in the coil magazine by a cutting knife. In most cases this unit leaves a small overhang, because at Edgebanders with a continuous process is a trimming saw for cutting that overhang. In some small machines and with increasing technological development at through feed edgebanders, the cutting knife unit is able to do a flush cut. Generally, two different sizes:
It is not primarily the Edge thickness determining, but rather the Edge cross section. Edge cross section = edge height x edge thickness Alternative terms, related terms
|
883
616
438
186
181
132
202
325
188
149
124
61
130
11
34
96
96